Asset Publisher

Active Pixel Sensor

Active Pixel Sensor

This page has been archived and is no longer updated.APS (Active Pixel Sensor) technology has been developed in the last decade, largely benefiting from the constantly progressing CMOS technology. Several advantages over CCD technology include: lower cost, lower power consumption (up to 100 times), higher dynamic range, higher blooming threshold, individual pixel readout, single low voltage operation, high speed, large array sizes, radiation hardness capabilities, random access, possibility to develop separately the "photon sensitive part" and the "signal conditioning part" and last but not least the possibility to integrate "intelligence" at the sensor level (so called SoC, "System on Chip"). The radiometric performances of APS are still not able to compete with the best CCDs available presently on the market for space application but the gap is thinner and thinner.

As far as spectral response is concerned, the UV range is only at the exploration phase, with the application of CCDs "recipes" like specific coating deposition. Backside illumination technology, already applied to CCDs, is one way to extend the spectral coverage of APS. Another very promising alternative is the hybridation of the readout architecture to specific substrate with targeted optical properties (such as Wide Band gap semiconductors), with the possibility as stated earlier, to optimize them separately.

Imaging payloads of the future ESA missions such as Bepi Colombo and Solar Orbiter could largely benefit from progress of the APS technology. Within that frame and as part of the 2004-2006 TRP (Technology Research Program), SCI-A is managing the following activities:

  • A 2048 x 2048 Active Pixel Sensor with improved radiometric performances for the visible imagers of the Bepi Colombo MPO (Magnetospheric Planetary Orbiter). The extension toward UV by suitable techniques should also profit to the Solar Orbiter imaging payload.
  • A 256 x 256 focal plane array based on APS for the NIR (0.5 to 2.5 μm) for the Bepi Colombo Near Infrared Imaging spectrometer. The use of HgCdTe substrate is a very strong option.

Star1000 chip - a 1000 x1000 pixel chip has a 15 um pixel size.

In parallel to these new developments, SCI-AI is currently developing an APS focal plane (based on the radiation hard STAR1000 sensor) in order to acquire additional expertise as well as in preparation to scientific observations campaigns (Optical Ground Telescope, 1 metre telescope in Tenerife) from 2005. Finally, as part of the Active Pixel Sensor development activity, a complete test bench for electro-optical performance evaluations will be operational by the end of 2004 in our laboratories. This test bench will consist in:

  • A monochromator (Cornerstone CS130) and integrating sphere setup to evaluate PRNU (Photo Response Non Uniformity, Gain, Spectral response, Quantum efficiency, Fill Factor
  • A micrometer size laser spot setup to evaluate pixel cross talk, pixel profile, PSF (Point Spread Function) and eventually MTF. The use of a USAF target is also foreseen
  • Calibrated Radiometer
  • High accuracy positioning system to perform the above mentioned operation

The test bench will operate typically from 300 nm up to 2 μm.

Last Update: 1 September 2019
9-Dec-2024 03:32 UT

ShortUrl Portlet

Shortcut URL

https://sci.esa.int/s/Apjv5LW

Images And Videos

Related Publications

Related Links

See Also

Documentation