Asset Publisher

Rosetta's last words: science descending to a comet

Rosetta's last words: science descending to a comet

15 December 2016

On 30 September 2016, at 11:19:37 UTC in ESA's mission control, Rosetta's signal flat-lined, confirming that the spacecraft had completed its incredible mission on the surface of Comet 67P/Churyumov-Gerasimenko some 40 minutes earlier and 720 million km from Earth. Rosetta was working up to the very end, collecting reams of science data as it descended towards a region of pits in the Ma'at region on the comet's 'head'.

Rosetta's final descent. Credit: ESA

Rosetta was targeting a point within a 700 m × 500 m ellipse, between two pits in the Ma'at region. Reconstruction of the final descent trajectory showed that the spacecraft touched down at 10:39:34 UTC at the comet, only 33 metres away from the target point and just inside a shallow, ancient pit. This accuracy once again highlights the excellent work done by the flight dynamics specialists who supported the entire mission.

The touchdown site was subsequently named Sais after a town in Egypt where the Rosetta Stone, for which the mission was named, is thought to have been originally located.

Right before impact, one of Rosetta's star trackers generated an event reporting a 'Large Object' in the field of view: this was the local comet 'horizon'. Upon touchdown, the signal coming from Rosetta was lost, and mission operators believe that this was most likely caused by the high gain antenna immediately off-pointing from Earth at impact. No further telemetry was received subsequently, indicating that the planned safe mode and subsequent shut down of the spacecraft likely occurred successfully.

OSIRIS imaging footprints during the final descent. Credit: ESA/Rosetta/MPS for OSIRIS Team MPS/UPD/LAM/IAA/SSO/INTA/UPM/DASP/IDA

Rosetta's last image was taken with the OSIRIS wide-angle camera about 20 m above the surface. Prior to that, much of the imaging campaign during the descent focused on the 130 metre-wide pit named Deir el-Medina, as shown by the blue 'footprints' in the plot above. As seen on 30 September, the camera succeeded in capturing detailed images of the inside of the pit and its walls. These images will be used to help understand the comet's subsurface and thus its geological history.

The trail of orange and red squares then reflects the change in pointing of the spacecraft's camera towards the impact site at Sais.

Pressure rising

ROSINA pressure measurements during the final descent. Image courtesy K. Altwegg

Several other Rosetta science instruments were in operation during the descent, including ROSINA's Double Focusing Mass Spectrometer (DFMS) and Comet Pressure Sensor (COPS). Both recorded data "down to the ground", as ROSINA Principal Investigator Kathrin Altwegg puts it. As reported on the day itself, and shown now in the plot to the right, ROSINA measured an increase in the surrounding gas pressure by more than a factor of 100 as the spacecraft neared the surface.

"We saw the gas velocity and ram pressure drop to zero before we reached the ground, suggesting there is an interesting acceleration of gas slightly away from the nucleus," says Kathrin. "We also collected good data with the DFMS, and will be looking at which kind of atoms and molecules were present in the gas."

Temperature measurements below the surface

Mark Hofstadter, Principal Investigator for the MIRO instrument, reported that good data were collected throughout the descent, with the last measurement made at 10:39:07 UTC at the comet on 30 September 2016. The MIRO team think the spacecraft was about 20 m above the surface at this point.

"For the last two minutes of data, our sub-millimetre beam footprint on the surface was less than 20 cm in diameter," says Mark.

Comet 67P/C-G viewed with Rosetta's OSIRIS NAC on 30 September 2016, 1.2 km from the surface. Credit: ESA/Rosetta/MPS for OSIRIS Team MPS/UPD/LAM/IAA/SSO/INTA/UPM/ DASP/IDA

During the descent, MIRO collected continuum emission data from the nucleus, providing temperature measurements ~1 cm and 5 cm below the surface.  

"Over the last few hours, we see temperatures varying between about 80 K and 160 K as our beam moved across the nucleus. We think these differences are due to topography and shadowing – but we still need to correlate the details with topographic models and OSIRIS images to confirm that."

"We also noticed that the temperature of our telescope rose over the last couple hours of the mission. We haven't figured out yet if that is due to the angle of the Sun changing, or if we were being heated by the nucleus as it filled more and more of the sky."

Mark also told us that MIRO's last spectroscopic measurement of water in the coma was made in a limb-observing mode on 27 September at 13:26 UTC. A very rough estimate of the water production rate at that time is about 1024 molecules per second, or the equivalent of two tablespoons. During its most active period in August 2015, estimates were in the region of two bathtubs' worth of water every second.

Comet chameleon

The Alice instrument also made observations at ultraviolet wavelengths all the way to the surface. The final spectrum transmitted was an exposure that started at 10:20:16 UTC and ended at 10:30:21 UTC at the comet, about nine minutes before impact. The Alice team estimates that the final data were collected over a range of about 1000 metres to 500 metres altitude above the surface, with each row on the Alice instrument covering an average spatial scale of about four metres.

At the time of impact, Alice was 8.5 minutes into a 10-minute exposure. The last communication from Alice was a housekeeping packet received at 10:39:00 UTC, about half a minute before impact. The housekeeping data included the count rate of the total ultraviolet flux over the Alice bandpass, which was being reported every 30 seconds, and which showed a steady increase in the UV flux during the descent.

Final spectra from Alice. Image courtesy A. Stern/J. Parker

Looking at the last hour of data from Alice as an overall averaged spectrum, the trend of the slope and lack of broad absorption features is very similar to previously published results. That is, Alice did not see significant differences in the surface composition at these high spatial resolutions when compared to observations over larger areas. There was also no obvious indication of small icy patches.

"Of course, these are very quick-look results that may change as we look more carefully at the data," notes Joel Parker, Alice's deputy Principal Investigator.

Data gathered from both Alice housekeeping and science telemetry indicated that the strength of a feature in the spectra nicknamed the 'chameleon' (the curved lines on the left side of the spectral image above) also increased throughout the descent.

"This feature has appeared throughout the mission with lots of variability, and we believe it is a result of dust and sometimes ions entering the instrument," says Alan Stern, Alice's Principal Investigator. "The morphology of the chameleon during this time period matches the morphologies seen during dusty time periods, indicating that there may have been an increase in nano-grain dust density as the altitude decreased."

The last off-nucleus observation that Alice obtained of the comet's coma was on 29 September, and was typical of limb spectra observed since the beginning of May 2016, when the comet was about 3 AU from the Sun. It showed that carbon dioxide outgassing was still on-going at the end of the mission, at greater distances from the Sun than seen when the comet was still approaching the Sun earlier in the mission.

"Overall, Alice worked exactly as planned throughout the end of mission and the descent, and provided an excellent dataset that will need much more detailed analysis," adds Joel.

Steady solar wind and cometary plasma peak

The Rosetta Plasma Consortium sensors also enjoyed a good ride to the comet surface, with steady solar wind measurements.

Artist's impression of Rosetta arriving on the surface of the comet. Credit: ESA/ATG medialab

"These data are actually very useful, providing us with a 'quiet' time reference profile covering a large altitude interval for a steady solar wind, which will help us calibrate the datasets that were took throughout the whole comet phase," comments Hans Nilsson, Principal Investigator for the RPC-ICA sensor.

RPC-LAP and RPC-MIP both reported very low plasma densities through the descent, though slowly and evenly increasing, similar to that seen by ROSINA-COPS for neutral gas. However, the plasma reached a broad peak of up to about 100–150 cm-3 (preliminary measurement) at about 2 km from the surface, before dropping off again. This is as expected for a plasma originating from the neutral gas released by the comet: its density must be low at the surface since the molecules found there have just left the nucleus and have not had any time to become ionised.

"There is some plasma structure to be seen, but not much: this counts among the weakest ionospheres we have seen at the comet, but as may be expected in the northern hemisphere, which was winter at the time," adds Anders Eriksson, Principal Investigator of the RPC-LAP sensor. "If there was any local outgassing from the Ma'at pits, it is at least not immediately striking in our data."

RPC-IES demonstrated that the ions in the coma showed a modest increase in energy while the total flux of electrons decreased very near the comet, as expected and in line with the reduced coma density observations. The increase in observed coma ion energy could have been caused by an increase in negative spacecraft potential as the density decreased – something that is being looked into.

Finally, RPC-MAG made measurements down to a distance of about 11 m above the surface, showing no increase in the magnetic field with proximity. This confirms the finding, made during Philae's landing in November 2014, that the comet is non-magnetic.

A dust free descent?

Of Rosetta's three dust instruments, only GIADA was on during the descent, with MIDAS and COSIMA completing their missions in the days before. As it turns out, GIADA did not detect any dust, but this non-detection is itself an interesting observation.

"During the final descent, the environment was like a clean room!" remarked GIADA Principal Investigator, Alessandra Rotundi.

ROSINA, MIRO, and Alice team members confirmed the GIADA view. For example, the water production rate observed by MIRO over the region where Rosetta impacted was likely far too low to lift dust particles detectable by GIADA off the surface. Any dust grains present must have been very small indeed to evade detection, below GIADA's limit of 50 micrometres diameter.

One last dust particle…

The last dust particle collected by COSIMA. Image courtesy M. Hilchenbach

Even though COSIMA was off during the final descent, the instrument's Principal Investigator, Martin Hilchenbach, told us that one last dust particle was collected during their final day of operations, on 27 September. At that time, Rosetta was about 20 km from the comet centre.

The particle has the name 'Yaman Evijarvi'. Earlier in the mission, COSIMA particles were named for COSIMA team members, but with thousands of particles collected, this list was soon exhausted. Instead, 'Yaman' was the next name on a random list of international names (this one from Turkey), and 'Evijarvi', the name of a Finnish lake, comes from the theme used by the team to identify time periods of dust collection.

The last secondary ion mass analysis by COSIMA. Image courtesy M. Hilchenbach

Martin commented that the last days of Rosetta were as busy as ever for their team, as the COSIMA primary ion source parameters had to be adjusted in the very last minutes to acquire the last secondary ion spectra. "I was really impressed that after 26 months of operations, the motivation was just as high as on the first day," he said. "In the end, our primary ion beam source outlived the total predicted hours of operation by a factor of two."

Martin adds "And as planned, we returned all of the dust particles we collected back to the surface of the comet on 30 September – cosmic recycling, over 700 million km from Earth!"

"It's great to have these first insights from Rosetta's last set of data," says Matt Taylor, ESA's Rosetta project scientist. "Operations have been completed for over two months now, and the instrument teams are very much focused on analysing their huge datasets collected during Rosetta's two-plus years at the comet.

"Data from this period will eventually be made available in our archives in the same way as all Rosetta data."

Last Update: 1 September 2019
21-Nov-2024 16:53 UT

ShortUrl Portlet

Shortcut URL

https://sci.esa.int/s/A1Gag9W

Related Publications

Related Links

See Also

Documentation

Further Readings